Building your own furniture with computer desk plans can be a fun experience. However, it is important to make sure that you follow all the necessary steps to avoid messing up the project. If you are building a desk, you should either find or create your own computer desk plans. Ideally, you will be able to get a large sheet of wood that you can use for several if not all of the pieces involved.
During the initial planning stages, it is necessary that you get exact measurements from the DIY desk plans. Doing so will ensure that all the parts of the desk end up fitting together properly. Do not guess or go through this part quickly as doing so will ruin the project later on.
Be sure to refer to the DIY desk plans for all the information. Basically, you need to transfer what is on the computer desk plans to the wood you are using with pencil marks that will allow you to cut properly. It is easier to use a jig saw than a table saw due to the fact that you need to make very precise cuts and you will be using the same piece of wood for most of the pieces.
After making all the necessary cuts as detailed in the computer desk plans, you are ready to start sanding the edges for a smooth finish. When that is done, you will be ready to start putting all the pieces together. This is done with wood screws that you coat in wax. You must attach the pieces with blocks of wood holding them together, so if the two pieces that you wanted to attach to one another were at a 90 degree angle, the block would be between the two. This should be detailed in the computer desk plans.
Once all the pieces are attached, you are almost finished. Hopefully, you have continued to refer back to the DIY desk plans throughout the entire process. If you have, you will be ready to do the final sanding and follow that with a complete paint job. You will have just successfully followed computer desk plans.
During the initial planning stages, it is necessary that you get exact measurements from the DIY desk plans. Doing so will ensure that all the parts of the desk end up fitting together properly. Do not guess or go through this part quickly as doing so will ruin the project later on.
Be sure to refer to the DIY desk plans for all the information. Basically, you need to transfer what is on the computer desk plans to the wood you are using with pencil marks that will allow you to cut properly. It is easier to use a jig saw than a table saw due to the fact that you need to make very precise cuts and you will be using the same piece of wood for most of the pieces.
After making all the necessary cuts as detailed in the computer desk plans, you are ready to start sanding the edges for a smooth finish. When that is done, you will be ready to start putting all the pieces together. This is done with wood screws that you coat in wax. You must attach the pieces with blocks of wood holding them together, so if the two pieces that you wanted to attach to one another were at a 90 degree angle, the block would be between the two. This should be detailed in the computer desk plans.
Once all the pieces are attached, you are almost finished. Hopefully, you have continued to refer back to the DIY desk plans throughout the entire process. If you have, you will be ready to do the final sanding and follow that with a complete paint job. You will have just successfully followed computer desk plans.
Daniel M. Fisher invites you to join the community of satisfied woodworkers who have claimed their free copy of the Ultimate Woodworking Compass with access to free computer desk plans, DIY desk information and much more. You will get free and instant online access to proven, detailed woodworking plans with photos for your own projects. Claim your copy of the Ultimate Woodworking Compass now at FreshWoodworkingPlans.com
Article Source: http://EzineArticles.com/?expert=Daniel_M_Fisher
0 comments:
Subscribe to:
Post Comments (Atom)